PULSE_V3_LoRaWAN_AS923_UG_V1.0.0_GB.pdf

PRODUCTS AND REGULATORY INFORMATION

<aside> 💡 This User Guide applies to the following product:

PULSE - LoRaWAN AS923 REfrence: ARF8230JA

Firmware version:

RTU version: V01.07.01 APP version: V02.00.00

</aside>

DOCUMENTATION GUIDE

PREAMBLE

DISCLAIMER

TECHNICAL SUPPORT

RECOMMENDATIONS

INTRODUCTION

COMPLIANCE TO RCM AUS NZ (produits de gamme LORA AU915 & AS923).pdf

TABLE OF CONTENTS

• TABLE OF CONTENTS

1. PRODUCT PRESENTATION

NOTE: the LoRaWAN AS923 PULSE can only be started or restarted using a magnet.

Description

• LoRaWAN AS923 PULSE is a ready to use radio transmitter that can be used to transform any type of meter into a wireless meter (smart meter). • This product meets the needs of users who require to remotely monitor the consumption of different fluids (water, gas, electricity, heat ...) or any other phenomenon with an impulse interface (rain gauge, odometer ...). • The use of the LoRaWAN protocol allows the user to integrate the LoRaWAN AS923 PULSE into any network that is already deployed. • Two 3 wires-meters or one 5 wires-meters may be controlled by a single LoRaWAN AS923 PULSE transmitter thus permitting a significant reduction in implementation and deployment costs. • The product emits the data from the meters periodically with or without history. It allows also the detection of tamper, and leakage, and the flow calculation with transmission possibilities on exceeding high or low thresholds. • The configuration of the transmitter is accessible by the user via a micro-USB port or remotely via the LoRaWAN network, allowing in particular a choice of modes of transmission, periodicity or triggering thresholds. • The LoRaWAN AS923 PULSE is powered by a soldered internal battery. IMPORTANT NOTE: The LoRaWAN AS923 PULSE is delivered by default with OTAA configuration, allowing the user to declare his/her product to a LoRaWAN operator For an ABP procedure, please contact our Sales Department with the necessary information. IMPORTANT NOTE: The LoRaWAN AS923 PULSE can transmit measurements from the meters but does not power them.